Seaweed granules circular sieve vibrating seperating works
By vertical vibration motor as the excitation source, the motor and lower ends mounted eccentric weight, the rotary motion of the motor into a horizontal, vertical, inclined three million sports, then this motion transfer sieved to adjust to the screen surface
Apply to industry
Chemical industry: resin, paints, industrial chemicals, cosmetics, paint, medicine powder.
Food industry: sugar, starch, salt, rice flour, milk powder, milk, egg, soy sauce, fruit juice.
Metal Mining: aluminum powder, lead powder, copper powder, ore, alloy powder, welding powder, manganese dioxide, copper powder, magnetic power, abrasive powder, refractory materials, kaolin, limestone, alumina, carbonate, heavy calcium, silica sand.
Pollution treatment: waste oil, waste water, wastewater dyeing, additives, activated carbon, etc.
New sieve separate design advantage
1.Save time(3-5 minutes to complete screen replacement).
2.Save manpower, for change screen just two people.
3.Increase fluency production line.
4.Increases screen life, bouncing ball does not directly strike a fine mesh.
5.Increase the screen using the area.
This machine is very simple and quick method for change screen,just follow the order shown below, no more than five minutes, can be done for change screen
Mechanical installation and adjustment
Mechanical installation
When the machine is moved to a particular position, the user needs to be fixed.But, this machine must be in a horizontal position,otherwise, it may affect the continuous operation of the machine.
The machine's power cord must be connected with switch of protective motor device.
Check before operation
1.Whether the machine at in a horizontal state.
2.Whether fixed base.
3.Whether pave fine mesh.
4.Whether locking screw beam ring.
5.Whether the machine contact with other items.
6.Whether power connected.
NOTES during operation
1.Whether abnormal noise.
2.Whether the motor rotation direction is consistent with the direction of the arrow.
3.Whether single-phase operation.
4.Whether the fine mesh is too loose.
Commissioning
If the appeal referred to are no problem,you can put a little raw material into the screen center position,according to the direction of flow of raw materials, adjust the machine.
1.Configure special rubber ring and bouncing ball.
2.Adjust the angle of the lower weight hammer.
3.Increase the weight of the upper weight hammer.
Adjustment methods of the lower weight hammer
Depending on the nature of the raw materials, in order to achieve optimal screening effect, can adjust the phase angle at both ends of the weight hammer, and more effectively change the trajectory of the raw material,extend or shorten the time material in the sieve surface.
Adjust the weight hammer part, basically just adjust the lower weight hammer, the upper hammer does not need changes.
Change screen
1.change fine mesh method
(1)First loose screw of beam ring , remove the frame, the fine mesh broken removed and replaced with a new fine mesh.
(2)The fine mesh tile in the mother mesh,again put the upper ledge back in place,fine mesh stretched by hand from the surrounding.At both ends of the machine on the side edge of the box, each using a universal clamp, the clamp on the upper frame and the next frame.
(3)The fine mesh around the protruding edge of the frame except reserved two centimeters, the rest all cut.
(4)Beam ring Again put, loose universal clamp. Then tighten the screw of beam ring.
(5) Evenly beat around the beam ring with a soft hammer,locknut,that completed the replacement of a fine mesh.
2.change mother screen method
Mother screen if damaged, repairable. If you can not repair, send back to the company for repair, should prepare more a set of mother screen backup.