K530 Stainless Steel Electric Or Gas Pressure Fryer,China FURNOTEL price supplier

Item No.	Product Name	Specification
K530-1	Electric Pressure Fryer	Dimension:460*960*1230mm Voltage:3N~380/220V    50-60Hz Power:12KW Temperature Range: 50-200 °C Capacity:24L
K530-2	Gas Pressure Fryer	Dimension:460*960*1230mm Voltage:220V    50-60Hz Gas Consume:0.48kg/h Temperature Range: 50-200 °C Capacity:25L

 

 

 

 

 

CHANGING THE Filter ENVELOPE

 

 

 

The filter envelope should be changed after 10-12 filterings or whenever it becomes clogged with crumbs. Proceed as follows:

 

 

1. Move the main power switch to the OFF position.

 

2. Remove and empty the condensation drain pan.

 

3. Disconnect the filter union and remove the drain pan from under the frypot. If available, a drain pan may have casters under it, allowing easy transport of filter pan and filter assembly.

 

 

 

Warning

 

This union could be hot! Use protective cloth or glove,or severe burns could result.

 

If the filter pan is moved while full of shortening, use care to prevent splashing, or burns could result.

 

 

 

4. Lift the screen assembly from the drain pan.

 

5. Wipe the shortening and crumbs from the drain pan. Clean the drain pan with soap and water, then thoroughly rinse with hot water.

 

6. Unthread the suction standpipe from the screen assembly.

 

7. Remove the crumb catcher and clean thoroughly with soap and water. Rinse thoroughly with hot water.

 

8. Remove the filter clips and discard the filter envelope.

 

9. Clean the top and bottom filter screen with soap and water. Rinse thoroughly with hot water.

 

 

Notice

 

Be sure that the filter screens, crumb catcher, filter clips, and the suction standpipe are thoroughly dry before assembly of filter envelope as water will dissolve the filter paper.

 

 

10. Assemble the top filter screen to the bottom filter screen.

 

11. Slide the screens into a clean filter envelope.

 

12. Fold the corners in and then double fold the open end.

 

13. Clamp the envelope in place with the two filter retaining clips.

 

14. Replace the crumb catcher screen on top of the filter paper. Screw on the suction standpipe assembly.

 

15. Place complete filter screen assembly back into filter drain pan and slide pan back into place beneath the fryer.

 

16. Connect the filter union by hand. Do not use a wrench to tighten.

 

17. Slide the condensation drain pan back into place. The fryer is now ready to operate.